Brand new high output Stator + External ignition coil + Regulator Rectifier + Flywheel puller Kit
- Tous les produits expédiés sont testés
- Toutes les photos des articles sont exactes ; en cas de doute, n'hésitez pas à comparer notre article à votre pièce d'origine
High output stator assembly 200 watts
- Remplacement direct de votre unité d'origine
- Plug-and-play, montage direct, installation facile
- Bobine de ramassage pulsar incluse
- Grommet included
- Connecteur inclus
- Adjustable timing +/- 10 degrees included
- Matériaux de laminage de la plus haute qualité
- Bobinage en cuivre de la plus haute qualité, résistant jusqu'à 200 degrés Celsius
Régulateur
- 12 volt regulator used by Baja winners
- Contrôle précis de la tension, élimine les risques de brûlure de la lumière
- Réduire le scintillement et la gradation
- Installation simple
- Works with all other OEM components
- Puissance nominale de 225 watts
Extracteur de volant moteur
- 27 MM x 1,0 Mâle gauche
- Compatible with OEM parts
Bobine d'allumage externe
- Remplacement direct de votre unité d'origine
- Plug-and-play, montage direct, installation facile
- Matériaux de laminage de la plus haute qualité
- Spark plug caps are included
- For solid tip spark plugs, you may re-use your spark plug caps
Avant d'installer votre nouveau stator
- Check the AC output of the stator. ﾠ
- Replace any burned or corroded connectors on stator and regulator/rectifier ﾠ
- Check and repair any melted wiring. ﾠ
- Use hi-temp dielectric grease on all connectors ﾠ
Before attempting to start your YAMAHA YFZ350 BANSHEE:
This stator is designed as a direct plug-in replacement and should be used as such.
Our stator may use a different wire color code then youﾒre original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
When bolting stator in, always use locking compound.
Adjusting the air gap is necessary, rotate the flywheel so the raised node is lined up with the pick up/pulser coil and adjust as close as possible but no less than 0.010ﾒﾒ.
Set adjustable timing plate at zero for stock timing
Regulator Rectifer
- Bolt regulator to frame.
- Ground Black wire to Frame or Harness Ground
- Connect Yellow Wire to AC Output lead of the Stator
