RMS900-106009 | Kit Generator Stator + Mosfet Voltage Regulator Rectifier for Polaris Sportsman 325 ETX / 450 HO / 570 X2 2014-2020 |
C$436.78
Generator Stator Dimensions
Interior diameter: 54 mm
Exterior diameter: 126 mm
Thickness: 19 mm
Length of wires stator to grommet: 85 mm
Length of wires grommet to plug: 290 mm
Other specifications :
Number of wires : 3
Number of plugs: 1
Number of pins : 3
Wire to wire resistance :
Alternator : Black between each Black = 0.4 ohms +/-20%
Mosfet Voltage Regulator Rectifier Dimensions
Width: 50 mm
Length: 112 mm
Height: 108 mm
Fixation holes center to center: 84 mm
Wires Length: 600 mm & 1200 mm
Other specifications :
Number of plugs : 3
Number of pins: 5
Number of wires: 5
Minimum Charging Voltage: 14.5 V +/- 0.5 V
Maximum Charging Current: 50 A / 500 W
Open Circuit Voltage: 15 V
Operation Temperature: -20⁰ to 85⁰
Available on backorder
Brand New aftermarket Stator + Mosfet Voltage Regulator Rectifier Kit
- Direct replacement to your original unit
- All product shipped are tested
Generator Stator:
Brand new aftermarket generator stator
- Plug-and-play, direct fit, easy installation
- Highest grade of of lamination materials
- Highest grade of of copper winding, resistant to 200 degrees Celsius
- Connector included
- Rubber grommet included
We have even included the opposite connector (main harness side), as we know these are often melted corroded defective and a major cause for repetitive electrical issues.
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.
When using this stator on 2016-2018 Polaris Sportsman 570 models, please pay close attention to the stator and regulator wiring harness routing. The OEM wire routing was very poor, and allowed the harness to rub against the motor, damaging the insulation and damaging the charging system. We recommend routing your stator/regulator wiring outside of the frame rail, and securing the harness to the frame with zip ties. This should prevent any future damage to the wiring harness.
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
Please Note: There are two possible stators for the RZR XP 900 and RZR 4 XP 900 models. This stator fits models built 3/16/12 and after (OEM # 4013013, stator thickness 19 mm). For the stator built 3/15/12 and before, the right part is RM01205 (OEM # 4013224, stator thickness 27 mm). Always check in the ‘Fits models’ section and please compare to your original part before buying.
Brand new Mosfet voltage regulator rectifier
Mosfet Voltage Regulator
- The quality exceeds the OEM equipment
- Improved heat sink and charging capabilities
- Higher grade of electric components
When using this regulator on 2016-2018 Polaris Sportsman 570 models, please pay close attention to the stator and regulator wiring harness routing. The OEM wire routing was very poor, and allowed the harness to rub against the motor, damaging the insulation and damaging the charging system. We recommend routing your stator/regulator wiring outside of the frame rail, and securing the harness to the frame with zip ties. This should prevent any future damage to the wiring harness.
Battery condition is extremely important. No voltage regulator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
There were 2 different regulators used on 2017-2018 Polaris Sportsman 570 models. Please compare your original to our pictures. Our RMS020-100174 regulator will ONLY replace an original that looks EXACTLY the same. The other possible regulator is RM30421.
Before installing your new stator
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Before installing your new voltage regulator rectifier;
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors.
| Weight | 2.52 kg |
|---|---|
| Brand |
RMSTATOR |
| Fitment Type |
Guaranteed Fit |
OEM AND OTHER PART NUMBER
OEM PART NUMBER
- 106009R00, 106009-R00, 106009.R00, 106009 R00
OTHER PART NUMBER
- RMS900-106009
DO NOT MANUFACTURE PARTS, DESIGN PERMANENT SOLUTIONS
We cultivate our actions towards finding permanent solutions. There is no way, us, as customers, would like to replace a part again and again. This mindset forces our team to design to fix, to conquer these pesky electrical failures in powersport.
GOOD DESIGN PRODUCE GOOD PRODUCTS. EFFICIENT DESIGN CREATES STELLAR PRODUCTS.
We are committing to innovate in finding clever ways to design more efficient parts that produce better results than any other part on the market.
WE ALL ARE CUSTOMERS ELSEWHERE.
In our shopping journey for buying our daily goods, we all expect to be treated with respect in a relation that makes us feel welcomed. Our team is encouraged to elevate that standard even higher and to provide all the information necessary for an easy and reliable installation.
OWN YOUR CUSTOMER PAIN LIKE IT IS YOURS
We own powersport rides ourselves. We feel the pain of dealing with unsolvable troubleshooting on our rides. We are committed in manufacturing complete solutions to known or I-would-never-have-suspected issues that are plaguing your rides... and ours.
| Type | Year | Make | Model |
|---|---|---|---|
| Type | Year | Make | Model |
| fitments are loading.. | |||
