RMS900-108893 | 250W DC Upgrade Kit Stator + Series Regulator for Honda XR 600 R 1985-2000

C$449.99

Stator:

Dimensions:
Interior diameter: 54 mm
Exterior diameter: 115 mm
Thickness: 15 mm
Length of wires stator to grommet: 140 mm
Length of wires grommet to plug: 900 mm

Other specifications:
Number of wires: 3
Number of plugs: 1
Number of pins: 3
Number of poles: 18
Wire to wire resistance:
Alternator: Yellow to Yellow = 0.5 ohms +/-20%
Alternator: Yellow to ground = O.L

Series Regulator:

Dimensions:
Width: 84 mm
Length: 90 mm
Height: 32 mm
Fixation holes center to center: 69 mm

Other specifications:
Number of plugs: 2
Number of pins: 5
Minimum Charging Voltage: 14.5 V +- 0.5 V
Maximum Charging Current: 50 A / 500 W
Open Circuit Voltage: < 15 V
Operation Temperature: -20° to 85°

   
   
SKU: RMS900-108893 Categories: , ,
Description

Brand new aftermarket 250W DC upgrade kit stator + series regulator
– Direct replacement to your original unit
– Plug-and-play, direct fit, easy installation
– The quality exceeds the OEM equipment
– Connectors included
– All products shipped are tested

Stator:
– Highest grade of lamination materials
– Highest grade of copper winding, resistant to 200 degrees Celsius
– Rubber grommet included

Series Regulator:
WHY USE SERIES ENHANCED TECHNOLOGY?
– Runs much cooler than the Shunt and MOSFET voltage regulator rectifier.
– Power only flows through the electrical components when the battery is charging.
– Allows the stator to have lower current flowing when not used, extending its lifetime.
– The regulator is easier to mount because it’s smaller than the OEM one.
With enhanced technology design
This product is an advanced technology that lowers operating temperatures for extended longevity and better performance than the OEM part.

THE SERIES VOLTAGE REGULATION TECHNOLOGY
RMSTATOR’s new SERIES voltage regulator brings better reliability and charging system performance. A SERIES regulator is a significant upgrade over typical shunt type voltage regulators. A shunt regulator controls battery voltage by grounding the stator coils to dissipate current as heat, rather than sending it on to the battery. SERIES regulators control battery voltage by intermittently disconnecting stator coils from the regulator electronics, limiting current flow through the unit and on to the battery completely. This results in lower regulator and stator temperatures, more accurate voltage regulation, and increased reliability of your charging system components.

Brand new series voltage regulator rectifier

THE ULTIMATE SOLUTION TO YOUR REGULATOR RECTIFIER PROBLEMS!
It is time to update or replace your voltage regulator with the advanced series type. It runs cooler than all OEM, Shunt or MOSFET, diode style regulators. In addition, this rectifier has overheat protection, rather than burn up it will simply turn off for a while and cool off.

– Higher grade of electric components

We even include the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause for repetitive electrical issues.

Additional information
Brand

RMSTATOR

Fitment Type

Guaranteed Fit

OEM and Other Part Numbers

OEM and Other Part Numbers

OEM Number : 

  • Honda# 31120-MN1-671, 31120-MK2-005, 31120-MN1-681, 31400-KA2-641, 31400-MK2-681, 31400-MN1-670, 31400-MN1-640, 31400-MN1-680
About brand

DO NOT MANUFACTURE PARTS, DESIGN PERMANENT SOLUTIONS

We cultivate our actions towards finding permanent solutions. There is no way, us, as customers, would like to replace a part again and again. This mindset forces our team to design to fix, to conquer these pesky electrical failures in powersport.

GOOD DESIGN PRODUCE GOOD PRODUCTS. EFFICIENT DESIGN CREATES STELLAR PRODUCTS.

We are committing to innovate in finding clever ways to design more efficient parts that produce better results than any other part on the market.

WE ALL ARE CUSTOMERS ELSEWHERE.

In our shopping journey for buying our daily goods, we all expect to be treated with respect in a relation that makes us feel welcomed. Our team is encouraged to elevate that standard even higher and to provide all the information necessary for an easy and reliable installation.

OWN YOUR CUSTOMER PAIN LIKE IT IS YOURS

We own powersport rides ourselves. We feel the pain of dealing with unsolvable troubleshooting on our rides. We are committed in manufacturing complete solutions to known or I-would-never-have-suspected issues that are plaguing your rides... and ours.